This Safe Saver Pin was developed to bring a container back to its original security level or higher. The pin is tapered at the end at such an angle that it will properly fit into the hardplate without extending beyond and interfering with the mounting of the lock. Even the smallest of hole saws will not allow the removal of the carbide. The ring grooves along the length of the pin are for easy depth measurement so that the pin can be cut to the proper length prior to being seated into the hardplate. This leaves room for a weld on the outer surface and/or cosmetic work. This Safe Saver Pin is recommended for use on any UL rated safe. Installed properly, it will, without question, take the repaired hole to a higher drill resistant level than the original hardplate. For repair of a 1/4 inch hole.
1/4" Safe Saver Pin Instructions